Very interested in this. I am wanting something to hover and follow on 10 mile run. Will I have to stop and keep programming it. Or will it follow for (2hours) approximately? Thanks you!
HOVERAir X1 Quick Start Guide
|
|
Lesezeit 2 min
Table of content
HOVERAir's Buttons How can I make HOVERAir X1 return to its starting point, land, or stop recording after use? Step 1 : Download App Step 2 : Charge the battery Step 3 : Power on Step 4 : Mode selection and fly Step 5: Landing HOVERAir X1 Step 6 Connect to the App Tutorials Want know more guide, check more articles:
HOVERAir's Buttons
How can I make HOVERAir X1 return to its starting point, land, or stop recording after use?
Intelligent flight paths: Upon completing the designated flight time, the HOVERAir X1 will automatically return to its take-off point or remain hovering in place.To initiate a palm landing, position your palm approximately 20 cm below the camera. The camera will recognize your palm print and land safely in your hand.In the absence of user input for more than 30 seconds, the HOVERAir X1 will initiate an automatic landing.
Manual control: Navigate to the bottom menu of the app preview screen and locate the "Landing" button situated on the far right.Tap the "Landing" button to safely land the HOVERAir X1.
How to begin? You can check our video or check the following steps.
The following are steps in details：
Step 1 : Download App
Scan the QR code below to download and install Hover X1 APP.
Step 2 : Charge the battery
Before you use HOVERAir X1 for the first time, be sure to charge it.
Video tutorial on charging your battery here:
Step 3 : Power on
Press and hold the power button for 2 seconds until the voice prompt is heard, and the green status indicator turns on.
Step 4 : Mode selection and fly
Open the HOVERAir X1 enclosureas shown below. You can switch modes using the mode button. Hold HOVERAir X1 horizontally. Short press the power button.
All propellers will start spinning. Release HOVERAir X1 and it will take off and perform the selected flight path.
Take off
Step 5: Landing HOVERAir X1
Place your hand 20cm below HOVERAir X1 when it is finished with its flight path, and it will automatically land on your hand.
Caution
DO NOT stick any finger or anything else into the propellers area. Please refer to the safety instruction manual and disclaimer on zzrobotics.com/ support for more information.
To stop the HOVERAir mid-flight, you can grab it from the air and press the power button or flip it by 180° to stop the propellers.
Step 6 Connect to the App
Open the Hover X1 App and use it to download your content or adjust flight parameters.
Tutorials
You can check the Hover X1 APP >Me>Academy or our official youtube video channel: https://www.youtube.com/@ZeroZeroRobotics
Want know more guide, check more articles:
See the ultimate guide of Hover X1 APP, go to Hover X1 APP introduction
Know how to fly HOVERAir x1 Safely, please go to Flying your HOVERAir X1 Safely.
See ultimate guide about the follow mode, go to The Ultimate Guide to HOVERAir X1 Drone Follow Mode
Want to know more about our acessories information like batteries and more, go to HOVERAir X1 Acessories Guide
