HOVERAir X1 Quick Start Guide

Intelligent flight paths: Upon completing the designated flight time, the HOVERAir X1 will automatically return to its take-off point or remain hovering in place.To initiate a palm landing, position your palm approximately 20 cm below the camera. The camera will recognize your palm print and land safely in your hand.In the absence of user input for more than 30 seconds, the HOVERAir X1 will initiate an automatic landing. 

Manual control: Navigate to the bottom menu of the app preview screen and locate the "Landing" button situated on the far right.Tap the "Landing" button to safely land the HOVERAir X1.

How to begin? You can check our video or check the following steps.

The following are steps in details：

Scan the QR code below to download and install Hover X1 APP.

Before you use HOVERAir X1 for the first time, be sure to charge it.

Video tutorial on charging your battery here:

Press and hold the power button for 2 seconds until the voice prompt is heard, and the green status indicator turns on.

Open the HOVERAir X1 enclosureas shown below. You can switch modes using the mode button. Hold HOVERAir X1 horizontally. Short press the power button.

All propellers will start spinning. Release HOVERAir X1 and it will take off and perform the selected flight path.

Take off

Place your hand 20cm below HOVERAir X1 when it is finished with its flight path, and it will automatically land on your hand.

Caution

DO NOT stick any finger or anything else into the propellers area. Please refer to the safety instruction manual and disclaimer on zzrobotics.com/ support for more information. 

Open the Hover X1 App and use it to download your content or adjust flight parameters.

You can check the Hover X1 APP >Me>Academy or our official youtube video channel: https://www.youtube.com/@ZeroZeroRobotics